Lift cables carry serious load alongside the springs. When one frays or snaps, we replace both cables as a pair and check the drums for wear.
Matching wear on both cables means both get inspected and typically replaced together.
A cable can slip its groove repeatedly if the drum itself is damaged, which we check before calling the job done.
Our technicians are trained to safely release and reset tension when cables are involved, not just the springs.
We carry the common cable lengths and gauges for most residential door sizes.
Each service below is handled by a technician trained specifically for this kind of repair, not a generalist guessing at it.
We replace the snapped cable and its pair, then verify even tension across both sides.
Catching a fraying cable early avoids the sudden, uneven drop that comes with a full snap.
If the cable keeps slipping off the drum, we look for a bent drum or misaligned track causing the repeat issue.
We match new drums to the correct diameter for your door's cable length requirements.
Correcting an uneven lean means addressing the cable, checking the spring pair, and confirming the track is still square.
Tell us if the door is hanging crooked or jammed, that detail helps us prioritize the call correctly.
Technicians carry standard cable gauges and lengths for most residential doors.
Diagnosis includes the drums, not just the visible cable, before any price is confirmed.
We verify the door hangs and travels evenly before calling the repair complete.
“Cable kept jumping the drum every few cycles. Turned out the drum itself was cracked, replaced and fixed.”
“Caught the fraying cable during a routine call before it actually snapped. Appreciated the heads-up.”
“Door was jamming mid-cycle for weeks. Cable and drum issue, fixed in one visit.”
One side losing tension while the other holds is the classic sign of a single cable or spring failure.
We recommend replacing both since they wear on the same cycle, and we'll explain the reasoning before you decide.
Yes, a door hanging on a single cable or spring can drop unexpectedly and should not be operated until repaired.
We check the drum groove condition whenever a cable keeps coming off, since replacing just the cable won't fix a bad drum.
You'll get a confirmed price on-site once the technician inspects the full cable and drum setup.
A snapped-cable call usually resolves in under two hours on-site.
Licensed technicians, flat-rate pricing, and a truck stocked for this exact job.
☎ Call +1-831-293-1591Technicians are positioned throughout Ellisville for fast response, and we cover the surrounding zip codes too.
Embedded Map Placeholder for Ellisville, MS